Tuning overhangs - Bambu Studio - Bambu Lab Community Forum
Por um escritor misterioso
Descrição
I’m trying to understand how to tune overhangs for my Polymaker ASA filament. I had dialed the fan speed way down to promote layer adhesion, except for overhangs. But overhangs came out shitty: I had: 0% fan @ 35s 20% fan @ 5s 100% fan for overhangs I then adopted the bambu ASA fan settings (leaving everything else the same): 25% @ 35s 90% @ 3s 80% for overhangs The result is much better: Notice that the bad model has 100% fan for overhangs and the good one only 80%. So is less fan
Why does prusa says that x1 takes 48 minutes to print a benchy? : r/BambuLab
Support Bambu Lab Wiki
Tuning overhangs - Bambu Studio - Bambu Lab Community Forum
Bambu Studio Fine Tuning: Tips And Tricks For X1 And P1P
Help with overhangs : r/BambuLab
How to show Overhangs in Bambu Studio @BambuLab #bambustudio #3dprinting #3dslicer
Print Quality Issue, Overhangs, X1 Carbon, PLA - Bambu Studio - Bambu Lab Community Forum
Print Quality Issue, Overhangs, X1 Carbon, PLA - Bambu Studio - Bambu Lab Community Forum
BambuLab
Why are my consistent overhang issues getting worse? - General discussions - Bambu Lab Community Forum
I must be doing something wrong. Help please comments. : r/BambuLab
Bambu Lab Slicer: Bambu Studio – All You Need to Know
Bambu Studio Fine Tuning: Tips And Tricks For X1 And P1P
de
por adulto (o preço varia de acordo com o tamanho do grupo)
